-
Low PIM Components: The Real Engineering Math From link budget to selection traps
Jun , 16 2026
Anyone who has worked on distributed antenna systems will eventually have a head‑on fight with PIM. This post skips the fluff and only shows the engineering math. 1. Where PIM comes from — the formula Two frequencies f1, f2 pass through a non‑linear node (loose connector, oxidized plating, magnetic material) and generate intermodulation products: 3rd order: 2f1－f2 , 2f2－f1 5th order: 3f1－2f2 , 3f2...
View more
-
Why Can’t a Power Divider Replace a Tapper in Indoor DAS?
Jun , 23 2026
Anyone who has worked on in‑building DAS eventually hits this problem: the main line signal is strong, but by the time it reaches the far‑end antenna port, there's almost nothing left. If you split it with power dividers all the way, each split makes it weaker, and the far end can't even get a phone registered. Then someone tells you — use a tapper. But what exactly is a tapper? How is it differen...
View more
-
What Makes a Tapper Indispensable for Long-Distance Indoor Coverage?
Jun , 30 2026
Anyone who has designed or deployed a Distributed Antenna System for a tunnel, a subway, or a 200‑meter office corridor knows this problem: the signal at the head‑end is strong, but by the time it reaches the far end, there's barely enough to keep a call connected. You can crank up the source power. You can add line amplifiers. But at some point, the physics of coaxial cable catches up with you. A...
View more
-
PIM Interference vs. External Interference: How to Quickly Tell Them Apart On‑Site?
Jul , 07 2026
Anyone who does base‑station maintenance or network optimisation eventually runs into this: uplink noise floor spikes, users complain about dropped calls and low throughput, yet VSWR tests pass and there are no equipment alarms. Where is the problem? At this point, you have two possible culprits – PIM (passive intermodulation) interference generated inside your own system, or external RF interfere...
View more
-
5 Ways a Bad Passive Component Can Ruin Your DAS Link Budget
Jul , 14 2026
Designing a DAS link budget is an exercise in controlled optimism. You calculate cable loss per 100 meters, add up splitter and coupler insertion loss, account for connector transitions, and leave a few dB of margin for things you can't control. Then you order the components, install the system, and turn it on. And the numbers don't match. Not by a little. By 6, 8, sometimes 10 dB. Coverage holes ...
View more
